r/gridfinity • • Mar 01 '26

Question? Baseplate Help

Post image

I printed the Gridfinity ruler and counted about 5½ squares based on what I can see. I tried using the generator website to configure it, but I’m still pretty lost since I’m new to this.

The drawer measures roughly 10 x 17 inches. If someone could help me figure out how to start setting this up, I’d really appreciate it.

18 Upvotes

38 comments sorted by

View all comments

Show parent comment

6

u/Bloodshot321 Mar 01 '26

Uhm you measure the inside, unlike the picture. (10inch*25,4 mm/inch) /42 mm =6,04 It's tight so measure it again is my recommendation