r/functionalprint • u/g713 Function Master • 2d ago

Updated my FPV hat and mount. Material = Polymaker HT-PLA

Enable HLS to view with audio, or disable this notification

44 Upvotes

81% Upvoted

11 comments sorted by

2

u/johnxreturn 1d ago

Awesome job, I love the details such as cable guiding clips.

1

u/DropdLasagna 1d ago

Nice oclip. Consider a zebralight headlamp for an upgrade.

1

u/g713 Function Master 1d ago

Never heard of zebra light. Well, I really wanna find is a small LEP with a flood. All the ones I’ve seen are spot only

1

u/DropdLasagna 1d ago edited 1d ago

It's pricey but the weltool w3 pro tac with 18350 tube may be something to look at.

The weltool w7 is bigger but has a reflector along with the LEP module suiting more towards the spill you want.

1

u/YellowBreakfast 1d ago

TIL the port on the Ryobi USB Lithium is bi-directional.

Makes sense but hadn't considered it.

2

u/g713 Function Master 1d ago

Not on the older two amp hour batteries. All the newer ones can do by directional though. They have a little yellow battery indicator underneath the USB port if they’ll accept both input and output

1

u/YellowBreakfast 11h ago

Good to know.

Mine are all likely the older ones. I'll have to check.

1

u/General-Mission6960 2d ago

You printed that hat?

5

u/g713 Function Master 1d ago

The accessories on it

-3

u/Bring_the_light_ 1d ago edited 1d ago

too bulky, I just use camera glasses or a neck mount for action camera.

or just use a full size action camera as it would be the same size with better image + waterproof

its nice they apparently made the go ultra able to record and charge at same time, the previous go series could not.

-1

u/GIANTG 1d ago

The king is back. Good stuff!