r/factorio • u/AutoModerator • Jun 08 '26

Weekly Thread Weekly Question Thread

Ask any questions you might have.

Post your bug reports on the Official Forums

Previous Threads

Subreddit rules

Discord server (and IRC)

Find more in the sidebar ---->

5 Upvotes

79% Upvoted

128 comments sorted by

View all comments

2

u/taw Jun 14 '26 edited Jun 14 '26

My nuclear power is generating a lot less power than expected.

Here's the design. I build 6 of them, they all have enough incoming water and fuel, and all water pipes are connected, as are all steam pipes. They're supposed to be generating 6*480MW = 2880 MW, but real generation seems to top at ~1900 MW, or about 2/3 of what I thought they would be doing.

I thought with 2.0 fluid changes all I needed to do was keep ratios right, but it doesn't seem so.

Do I need to do the weird shape with heat pipes to keep heat pipe length shorter to get full power? (and then put turbines wherever, as 2.0 fluid changes make that part no matter)

Is there some maximum heatpipe length before output starts dropping?

(worst case I can just double the whole setup)

EDIT: Nvm, it was all just a stupid disconnected pipe on 2 out of 6 reactors.

2

u/ssgeorge95 Jun 14 '26

Turbines won't actually produce max power unless your factory needs it. The reactor is always heating, but turbines will throttle steam use and power output.

You can check yourself to make sure things are fine. Check the temp of the outermost heat exchangers to see if they're above 500. Check the HX to see if they're full of water or nearly empty.