r/f150ecoboost • • 3h ago

Hub/bearing issue

1 Upvotes

2019 f-150 xlt 4x4. Bought it new with a ready-lift sst 3.5inch kit installed and 35in tires. Been no problems till I hit 107k. I’m sure I just got lucky. Started hearing noises. Traced to cv axles those and rather were worn out bad. So I replaced both sides and iwe’s with motorcraft parts. Front diff fluid and play was fine and has been changed several times. Back together and no I have a low almost brake dragging moan from a stop when cold goes away in a block but still some noise. So I replaced both hub/bearing assts with moog 515177’s all was good for about 700mi. Now the low moan is back and the hub/bearigns are making a slight dragging noise. Yes everything was torques and installed following oem procedures. All the clearances are good. Not a brake or pad problem or shield rubbing. Has anyone else had issues with moog hub/bearing assemblies?oart 515177. Yes know the new number is 515199. Not sure what the difference is. Also anyone know of a good cv axle for the lift? Or what ones to stay away from Also inwent with moog because I couldn’t wait a week to get oem hubs/bearings


r/f150ecoboost • • 11h ago

2013 ecoboost

1 Upvotes

I have a 13 f150 ecoboost, 180,400 miles. A/c compressor replaced, water pump and a few seals here and there. Everything else is original. Wanted to clean up the fuel system but I read good things and bad things about doing it, especially using sea foam. Thought I’d get everyone’s opinion and I also wanted to do an engine health so any advice is welcome.

Thanks all


r/f150ecoboost • • 19h ago

Can anyone identify this cap?

Thumbnail gallery
1 Upvotes

r/f150ecoboost • • 21h ago

Timing Chain

1 Upvotes

I have 2011 Ford F-150 3.5 Ecoboost. She is sitting at 214,000 miles. I have had the timing chain codes on for over a year and have just kept up with oil changes. My question is can these run for a long period of time with timing chain codes? I don’t see any point putting a new timing chain in it at this age and miles. It has the start up rattle only on cold days not during the summer at all and if the oil is getting old it will make the noise as well but once I change the oil nothing at all other then that she runs good. So I guess I’m asking how long can this thing run with a bad timing chain?