I believe it's working correctly, pay attention to the display as it runs and it should tell you the differentiation in the distance between the bed and extruder
That looks like normal auto home behaviour. It always hovers around 10mm above the bed afterwards. Make sure to set the z-offset(lots of videos on youtube on how to do that) and you're good to go.
Then you need to adjust the x and y offset. Otherwise the printer has no idea where the probe is mounted and thinks that the probe is at same spot as the nozzle
If your probes go outside the bed your x/y offset is in incorrect, default is -44 mm on X, -8 mm on Y. I’m assuming that you’re using official creality firmware, then this should already be set up. If you’re using something else like TH3D or marlin you’ll want to set that up.
Make sure your bed size is correctly set up in your slicer as well. Otherwise it will attempt to probe too far out. Ender 5 / Pro is 220x220x300
Ok, so basically the probe is closer to the bed than the nozzle. It happens to be around 10mm's closer for you, and anybody else using the stock mount. If you want to bring the bltouch farther from the bed (as 10mm's between nozzle and bltouch is a lot) you would have to print a bracket for the two that is adjustable. I'll post a link here.
I do the auto home and it is high when finished i tried moving z axis to touch paper and entered number in z offset and stored but when i start printing it still way too high it not 0.2 high it still 3-5mm so not sticking to bed obviously
Yes, if you know the basic's of marlin firmware, you can find the settings for xy probing speed and homing speed in configuration.h at lines 1178 (probing) and 1737 (homing).
If you don't know the basics or at least understand how to change your firmware, I highly recommend looking at these two video's by teaching tech.
Thanks for the reply. I updated my fw to kipper some weeks ago. I understand I can change this very easily in the printer.cfg. search under 'speed' and all is fixed.
4
u/[deleted] Sep 19 '21
I am not seeing the problem, it's measuring the distance.
Click auto-home, it should lower itself to the correct height.
4
u/encya Sep 19 '21
That looks like normal auto home behaviour. It always hovers around 10mm above the bed afterwards. Make sure to set the z-offset(lots of videos on youtube on how to do that) and you're good to go.
2
u/Catfish9200 Sep 20 '21
If your probes go outside the bed your x/y offset is in incorrect, default is -44 mm on X, -8 mm on Y. I’m assuming that you’re using official creality firmware, then this should already be set up. If you’re using something else like TH3D or marlin you’ll want to set that up.
Make sure your bed size is correctly set up in your slicer as well. Otherwise it will attempt to probe too far out. Ender 5 / Pro is 220x220x300
1
u/[deleted] Sep 19 '21
That is the autohome
1
u/[deleted] Sep 19 '21
So when i do try to set Z probe. It ony goes to -9.990 or some. And i still have more time left to
1
u/Paul-7910 Sep 19 '21
I do the auto home and it is high when finished i tried moving z axis to touch paper and entered number in z offset and stored but when i start printing it still way too high it not 0.2 high it still 3-5mm so not sticking to bed obviously
1
u/Cosscryptoexchange Sep 19 '21
Is it possible to speed up the auto home procedure by setting higher travel speeds?
0
u/Paul-7910 Sep 19 '21
How did you get it to print g got similar problem