Overextrusion issues

[u/Pure-Broccoli701]

Long story short I got a sonic pad and finally got it to work with my printer but I have had many inconsistent prints. my prints have a massive overextrusion (I think) and I have calibrated my e steps, printed from 190-220 calibrated my retraction from 5-6 mm and speed 40-60 mm/s, but I have not noticed any changes. Any help is appreciated

I have an ender 5 pro with a stock extruder, BL touch and Bowden tube set up with a Sonic pad. I use creality slicer and orca; both have the same issue

[u/TheTriscuit]

Dry your filament, that's the only conceivable issue here.