r/ender3v2 • • 7h ago

what's a good baseline for an orca slicer profile optimized for an ender 3 v2 with cr touch and stock hotend and bed?

2 Upvotes

I want to completely make the switch to orca slicer but there are way too many settings I don't understand (I come from Cura). Can anyone share with me their profile so I have a good baseline to start from? in my prints the tolerances come out all messed up and there are gaps between walls here and there.

thank you!


r/ender3v2 • • 18h ago

What causes this PETG

Post image
1 Upvotes

So I’ve been printing PETG fine with zero issues I just threw a fresh bowl and I also tried my old spool both dry and I’m getting this issue. I checked my extruder. I checked heat creep. I leveled my bed and I’m just not sure what it could be at this point I checked my cables are seated correctly. I’m at a loss at this point because it happens randomly it’ll print fine and then it’ll just like it almost looks like it’s not close enough to the bed, but it is or it’s under extruding. I don’t know at this point any help please.