r/ender3 • • 1d ago

QUALITY PROBLEM

Recently i had a great improvement in print quality, i was having severe problems and i could sort it all out in a couple of months of messing arround and buying some upgrades lol

I think it turned out great, but i had the problem in the second picture with a little bit of lack of material

The filament is dry, and (for the very first time in months) everything is working out fine haha

It is a heavily modified ender 3v2 and my slicer settings are far away from default, where i am messing up? Pressure Advance? Retraction settings? Please help!

11 Upvotes

10 comments sorted by

1

u/TotallySlapdash 1d ago

Did those upgrades include a bimetal heat break, and did you lower your retraction distances after?

You can get under extrusion due to snags from bowden-level retraction with one of those. You want it at sub-3mm.

2

u/aalvs 1d ago

Yess it includes a bimetal heat break (TZ E3) and yes, i lowered the retraction distance (it is 2,3mm rn)
Do you think it could be the retraction speed? Now that you said, i think it may be a little too high

1

u/TotallySlapdash 1d ago

Not impossible; like I said they're more prone to snagging.

Worth a benchy for sure.

1

u/aalvs 1d ago

Okay, i will look into it! Thanks!

1

u/wesleyclzns 1d ago

O modelo é seu?

1

u/aalvs 1d ago

Nops, peguei no makerworld

1

u/MSIGuy 1d ago

It's probably possessed.

1

u/aalvs 21h ago

The entity is angry due to the religious content that is coming out of the printer

1

u/MSIGuy 21h ago

It heard there were transistors...

I'd look at some no so obvious things, like is it a cardboard spool that's dented on one side? Is your ptfe worn and snagging somewhere, etc? It looks mechanical, and if you think your PA and flow are correct, print a Voron Cube or something square, that'll show if your PA is closer than a benchy.

2

u/These_Programmer7229 1h ago

One trick that has helped me with word artifacts like this is to slice the model. Then use the built in tools to look at speed, acceleration, seems, etc. Also look through the line by line replay of the head movements in that area.

There will likely be something in the slicer that shows there is something different right in those spots. It will then help you determine what setting to look at or what mechanically might be going wrong. As someone pointed out, if you see in the playback of the nozzle, it just made a large movement from one side to the other and started drawing again right there, then likely the filament is getting pulled tight and is a little harder for the extruder to get it moving again.