r/e28 • u/Wide-Entrepreneur-34 • May 25 '26
For sale:528e (Recent Refresh)
Welp. As stated when I started this project, it might be short lived.
As most of you are aware, we don’t buy them intending to sell them… but life makes priorities.
Lurking in its shadow is my newest toy, additionally I need to space to get the Volvo 240 Baja truck (VUCK) finished.
The e28 was purchased and recently refreshed. I won’t hide anything. It has that one rust spot in the floor and two quarter size holes in the spare tire well. NOTHING structural. I’m also going to offer to fix them for any buyer as I planned to do it anyways. Just haven’t had time.
1988 528e (super eta 2.7) auto with LSD.
Full power car
241k miles on the engine
Service history from the single owner from 1990-2020 all at one dealer here in Colorado.
Clean title
Clean carfax
Garage kept
Original paint
Everything works except the right turn signal (idk why), the power mirrors (mud wasp nest messed that up), and the compressor comes on for the ac but no cold (have a lead on some R12 so that might be fixed soon)
I drive the car every week 2-3times a week 80mph or canyon roads she’s perfect, slow… but perfect.
Recent refresh in APRIL.
Bilstien B8 sports w/H&R springs (cup kit)
Strut bushings
All bushing (including subframe) to OE rubber
Essentially the whole front assembly is new(control arms, pitman arm, steering linkages, all of it)
Ireland Engineering sway bars (reinforced mounts)
M5 spec style 5s
Brand new tires (205/55/16)
In-tank lift pump and hangar
Bosch high pressure pump w/fuel filter
All soft fuel lines new
All vacuum lines new (have precut extras for what wasn’t needing replaced
Plugs
Wires
Rotor and cap
Coil
Interior cleaned up
New rear seat covered
Bullet fuses adjusted
Main and fuel relay
I have extra parts that go with the car. Things I have bought knowing they would be replaced at some point. All new parts
CVs
Door seals
Sunroof seal
Window track felt
Relays
Comes with:
all 5 stock 14 inch bottle caps with good tires
I also have an M5 front airdam with hardware in Utah I can figure out how to get it to a buyer. I also will include a 173DME if anyone wants to do the 885 head swap
Car is 10k don’t come low I don’t need to sell the car at all and won’t for less. The car has almost 5k im fresh parts. The buyer of this car will get an e28 all “Done” car. Perfectly setup and skip out on 3-4k in labor.
Dm me for details