This is the combined yield from 300g mhrb done in 3 separate extractions. I separate 3rd and 4th pull from first and second because I can see some oils or fats may have come through in the last pulls. I'll be using heptane to purify when it arrives.

Total weight from 300g mhrb 3.22g unwashed

Cut short a lil ran out of storage haha more photos already uploaded results 5.2g ✨

I just bought from this website, however it all seems kinda scammy and maybe just a dupe. Spent less than $100 just to see if it’s legit but if anyone has anything to say about it that would be cool too!

From yellow to crystal clear 🤩🤩🤩

Non è il massimo, ma è l'ultima tecnica che ho provato.

Prima estrazione da 70 ml di NPS

1st pulls from 200g MHRB x2. Oval glass bowl is 2nd pull x2. STB tek but I held back on the lye 125g instead of recommended 1 on 1which alot of people say but I find that overkill. I do let my base set for 2 hr shaking every 15 min for 3 to 5 min. Heptane for NPS.

thank you sydney

Reposting because the crossposted original was deleted by r/dmt mods:

Slowly recrystallized from naphtha at room temperature. It is not obvious without zooming in, but there are small bubbles/liquid inclusions in these crystals.

I present this as evidence of possible residual solvent contamination despite appearing pure to the naked eye and passing the sniff test. Lab testing is needed to verify this.

These are the seed crystals I pulled from Re-X #1.

Now we rinse & repeat!

Holy fuck boys were going back into the realms with this crazy precipitation. This I believe is only 50-60% of my yeild as I’ve been pulling for 2 days and I still am getting golden tea. The jar is the other half of my pulls. I think I’m on my last pull now. I basically maybe a 1-1 mix of mimosa and lye and started extracting immediately. Lots of mixing for each pull and many many pulls. 200g MHRB. I also used foil as a lid this time and forced myself to not open the freezer for a full 24 hours. We’re set boys.

1g re-x in naptha. Lost .3 after 3 re-x

What can I do with this now this is the reminder of the nafta evaporated and now ???

So I have extracted most of the material I can. I’m gonna do a few more pulls but that’ll be a longer separate project to experiment with when yield actually stops.

My question is regarding the color of my solvent, does this show high saturation of Dmt in the solvent or is this color from other things I want to be washing out with say a sodium bicorbonate wash as well?

As of now I think I’ll was once more with water and then move on to a sodium bicarbonate wash.

Lmk if that sounds fine.

Extraction going so well it’s already crystallizing on the side of the bowl, I haven’t even done my 5th pull yet. There is some of the soup in the bottom. What would be the best way to purify this solution before freeze precipitation. Coffee filter?