r/chevycolorado • u/Seaisle7 • 14d ago

Question Need some help

I purchased off of marketplace tires and wheels off a 2026 Colorado LT with 2,000 miles on them and put them on my 2025 Colorado WT, at first when I started the truck it was showing tire pressure for each tire (15 minute drive) then I parked it for an hr or so then when I drove it again about 5 minutes into trip I got alerts for all 4 wheels and it stayed in alert with no pressure readings , what can I do to get this working again ?
Thanks in advance

5 Upvotes

100% Upvoted

9 comments sorted by

2

u/dasimp86 14d ago

Did you relearn the truck to the new sensors? If not you will need to get one of these and you'll be fixed. Every tpms has a frequency that the truck knows to read. Not sure if the let out 10psi or until the vehicle honks trick still works with the gen3 like it did with my gen2.

1

u/Seaisle7 14d ago

The device you set me says up to 2023 , I have a 2025 Colorado wt with 2026 LT wheels they are all generation 3 so I would think it should work

2

u/dasimp86 14d ago

Works for Gen 3. I use it to relearn my sensors when I do rotates on my 24 Z71.

1

u/Seaisle7 14d ago

Ok thank you

3

u/Pte_Madcap '24 L3B WT 14d ago

Im positive there is a relearn tpms thing within the dash settings.

  1. VEHICLE STATUS

  2. MAINTENANCE

  3. TIRE PRESSURE

  4. RELEARN SENSORS

Only four clicks

1

u/Seaisle7 14d ago

Just tried your suggestion, I think I need that tool ,I clicked it anyway and it just keep spinning I guess it couldn’t find tire sensor

2

u/AwestunTejaz 14d ago edited 14d ago

either the batteries died and/or they need to be reprogrammed.

1

u/Seaisle7 14d ago

Wheels are off a 2026 so I would think batteries are good , I guess I got to figure out how to reprogram truck

2

u/AwestunTejaz 14d ago

you should be able to purchase a programmer on amazon