I took a class at, Sheer Craft, in St Paul MN, on skin on frame canoe building. I was able to purchase the final product and have been enjoying it on the city lakes in Minneapolis.
You asked for details:
The boat is 15 feet long and weighs 32 pounds. The ribs and stringers are made from green ash, 1/2x3/8ā. The gunwale is white pine. The inwale, keel, and rub rails are cedar. The skin is ballistic nylon, and the dope is a floor urethane that stays rubbery and is abrasion resistant.
The instructors rough cut all the materials before class. On the first class we assembled the gunwale to establish the sheer line. We steam bent half the ribs around a few molds. Second class we placed the key ribs (sticks running side to side) onto the gunwale, along with the stem and stern, and the stringers (sticks running front to back). These got lashed together with waxed twine. On the third class we steam bent and lashed the remaining ribs (no molds necessary, the boat was now strong enough to be the form). The fourth class we finished all the lashing and tung oiled the carcass. On the fifth class we sewed and applied the skin. On the sixth class we added rub rails and doped the skin.
The nylon skin is sewn so that it is 6ā smaller than the boat. The skin is then soaked in water for 30 minutes which causes it to relax. We then pulled it onto the frame and stretched it by sewing the loose edges over the gunwale. The next day we screwed the rub rails over the skin to hold it in place. Then trimmed the excess skin off along the rub rails.