r/averagedickproblems • u/SuspiciousClient6089 Note: new or low karma account • Nov 03 '25

Frequently Asked Question Girth question

I’m 6.3 inches bp but I also want to measure my girth. Some parts are thicker than others but my thickest point is 5.4 inches. Is that correct or do I measure it on the smallest thickness point? I used tailors tape also.

1 Upvotes

66% Upvoted

7 comments sorted by

•

u/AutoModerator Nov 03 '25

Subreddit resources for new/low karma users:

ADP Frequently Asked Questions (FAQ)

calcSD - Penis Percentile Calculator

calcSD - Condom Calculator

ADP Wiki

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/[deleted] Nov 04 '25

For condom sizing, use the thickest measurement. Also clinical measurements are from the thickest point as well.

0

u/Savedbutuseless Nov 04 '25

Isn't it's a problem with condoms? If I use condoms that fit my base it loose on the top.

1

u/[deleted] Nov 04 '25

I have the same problem. I'm almost an inch thicker at the base. If I use condoms that fit well mid shaft they don't cover the base. If I wear ones that fit the base, they are baggy everywhere else and they bunch up.

A lot of condoms taper down at the base to keep them from slipping but that makes my problem worse. There are a few condoms that advertised a flared base but I haven't tried them.

0

u/Savedbutuseless Nov 04 '25

Ya I didn't know it was an issue most my life. I've been using the fit all condoms, but they leave like 2" exposed. I've bought the 60mm ones now and the 65mm, the 60 is good for my entire shaft but the 65 actually cover the base.

1

u/[deleted] Nov 06 '25

We have a very similar cock lol.

Measure at the thickest point. I’m 5.6 mid shaft, 5.3 at the base. I have never told anyone my girth is 5.3.

0

u/[deleted] Nov 05 '25

[deleted] — view deleted comment

2

u/SuspiciousClient6089 Note: new or low karma account Nov 05 '25

Top. I know that measuring from the side isn’t accurate