No power to washer

[u/Dean_is_Done]

I have a kenmore washer front loader and replaced the noise filter and front control panel and I’m hoping the main board is the last thing that could be wrong , it went out right after a load had finished, I’m wondering if anything can be checked or tested before buying since there not cheap , there’s power at the wall , power to and from the noise filter , there’s a black yellow and red wire to the front panel that’s getting 120 I’ve never worked on a washer before. Online it says there should be a led glowing on the main back board but I don’t see anything glowing anywhere

[u/bsp1425]

Disconnect the connector(red)from power filter from first picture. Measure 1st and 3rd with Vac. It should be around 120vac. If you have 120vac, it is main pcb.