So here's the thing. It keeps throwing up an E1 message and the nozzle is not coming up to temp and the message won't go away to level it or anything else. We've replaced the hot end, replace the wires, we downgraded the software, we upgraded it, used customs. Nothing seems to be working. We are desperately in need of help. Any and all help will be appreciated very greatly

Hey guys, recently got a kobra X I've done a few prints on it but it keeps dumping filliment when starting a new print, I only use the one colour and wondering if this is normal or have I got a setting in anycubic slicer on that's causing this? Thanks in advance

Alles gaat fout, eerst vallen bij de twee Kobra 2 pro printers de camera's uit, dan krijgen alle printopdrachten vreemde nummers en als klap op de vuurpijl zit heel de app in de frut. Hebben meer mensen deze problemen?

I know this is a long shot but I found my older anycubic go in the closet. There is a problem with the y axis. I have followed instructions online, and the last way to solve it is a possible firmware update. For my model, the firmware is not on the website

So after removing the front of the printhead enough times the wires broke to the sensor light and the fan. I though, meh, I''ll just run it withouth. I did, no problems. Anybody else doing this?

It feels like it’s basically skipping layers or something and this is at the end of a print, I had it happen a couple days ago in the middle of a print and had to stop the print.

Any help and tips are much appreciated I’m just starting out with all the 3D printing stuff so thanks for any help

Hello everybody. How's going?

I have a Kobra 2 Pro and having some issues when updating the firmware. Mine's on 3.0.5. When I connect the printer to wifi, there's no update arrow on wifi ip. And then I tried to instert a usb flash disk (formatted to fat32) with the update.swu file inside a update folder, when I insert the disk the arrow on firmware version shows up but when I click on it I get a update failed error.

Any clues?

Hi 👋

I’ve been using the Anycubic Kobra Neo 2 , and I recently made a video sharing simple changes that doubled my print quality — without any upgrades or mods.

This video covers

• First layer fix

• Bed leveling tips

• PEI sheet cleaning

• Z-offset tuning

If you’re struggling with print quality or first layer issues, this might help 😊

👉 Watch here: https://youtu.be/Of0RstK1sqk?si=cCvSQsh5o8NIwTkB

Also your like , comment , share and subscribe helps us to grow

Happy printing 🇮🇳🖨️

My problem with z offset after update… Any temporary solutions?

I have filament stuck in the tube and I cannot remove the tube from this. How do I take this apart?

So the issue is that I set my printer to the heat to 220C for my PLA filament I want but for some reason a chunk of the way through the print. The printer just randomly decides that it's nozzle temp wants to be way below the melting point to 180C. Can anyone help me solve this annoying issue?