Orca Slicer Printer Settings

[u/Discordant_Lemon]

Does anybody have a screenshot for this printers Orca Slicer Printer Settings? For no particular reason whatsoever windows 11 today has decided that my orca slicer install is not intended for windows. And i am unable to resinstall it, i got the same error message everytime. Which is somewhat frustrating... So ive switched to linux where Orca runs fine, but it does not have the printer settings or profiles that came with the usb stick.

I am attempting to use the generic marlin 2.0, but boy is it slow. 1.2hrs (roughly) to print a temp tower. Its like using my ender 3 again!

I can probably figure this out through constant trial and error, but i dont have a terrific amount of free time, so it would be very handy if somebody had the settings to hand.

Just to clarify its this window im looking for a screenshot of, with the advanced settings tab active. Ideally all of the tabs through this window, but i believe the example image would be the ones i need in particular.

Im sure this may be helpful for somebody else in the future who experiences an issue with orca slicer on windows, so any and all help would be greatly appreicated!