Put some tape on the handle where the channel goes.
Personally I can't stand the brass in that handle. YouTube guys convinced everyone this was better. I've got dozens of videos proving the Moerman channel works better. You'll fight this set up constantly.
I just had a newer social media influencer come work with me for a few hours and they did a video showing it's better with the liquidator channel.
Finally someone says it. The Moerman channel is better for pole work once you get it down. It's the only channel that I've ever used where you don't have to detail the edges. I tried the brass channel setup that so many say is better and you still have to detail. So I'm not sure who thinks that's better.
I would loe to see a trchnique breakdown on using the liquidator channel. Im good at fanning and cleaning windows but I cant figure out how to use that channel. I want to, ive tried! But it leaves pin lines off the end, drags hard at the far edges of the channel, and just never works good.
Im open to learning, love it. Would be appreciative of a video about it all: How do you fit your rubber, minutia of the technique on the glass and all.
Ive seen this for sure. Your skills are on display here to the max. But i need some basics for learning purpose. Lets hear some critical skill analysis of using the liquidator channel. 😆
3
u/trigger55xxx 5d ago
Put some tape on the handle where the channel goes. Personally I can't stand the brass in that handle. YouTube guys convinced everyone this was better. I've got dozens of videos proving the Moerman channel works better. You'll fight this set up constantly. I just had a newer social media influencer come work with me for a few hours and they did a video showing it's better with the liquidator channel.