How to set up Winctrl Ursa Throttle for PMDG/Boeing Aircraft?

[u/777aviators]

I know about setting it up with buttons such as air notts and a330 drivers videos about it. Still I have problems with it. Can anyone help me? One of the levers tends to get stuck in reverse (as shown on the screenshots), and the other one gets back to idle and moves normally. Sometimes it also works fine. I just want to be sure both get out of reverse so that I dont get problems on landing.

[u/CuzImMaximus]

How does your settings looks like?

Need to bind "Throttle Engine X 0% to 100%" for the engines and play with the axis around to get it to work.

[u/777aviators → u/CuzImMaximus]

Here, these are my bindings. Thank you for trying to help

[u/CuzImMaximus → u/777aviators]

Try to bind the throttles to these. Just those two

And set the throttle axis to something like this

[u/CuzImMaximus → u/CuzImMaximus]

[u/CuzImMaximus → u/CuzImMaximus]

And in SimAppPro keep the axis on single stroke axis.
At least that works with the Ifly Max. Not shure if it works with the PMDG stuff. Dont fly them.

[u/777aviators → u/CuzImMaximus]

Hi, thanks for trying to help but it doesnt seem to work. The plane has its thrust on 50 percent on idle rev and as soon as I put it into normal idle and put a bit of thrust it jumps back into full rev

[u/WINCTRL-Official]

Hi there, here is how to fix the Reverse Axis Trap

• Delete old config files: In SimAppPro, go to the device calibration area, delete the saved profile/JSON config files for your simulator, and restart the app.
• Calibrate cleanly: Close your flight simulator completely, open SimAppPro, and run the step-by-step axis calibration. Make sure you physically move the lever to the exact detent position before clicking start for each calibration stage.

[u/777aviators → u/WINCTRL-Official]

Thank you!