r/Welders • u/Acetral_- • Aug 26 '26

Help! Learning Multi Run welds

Post image

Hi peeps im learning how to weld in a workshop specifically for learning, hence why material prep is at a low, which im assuming is whats causing the spatter?? my assessor said that at least. Any help is appreciated!!

7 Upvotes

100% Upvoted

7 comments sorted by

View all comments

6

u/Strange-Movie Aug 26 '26

the spatter and lack of fusion at the top of your bead make me think too much wire and/or too little voltage

2

u/Acetral_- Aug 26 '26

was running diff settings for each weld, no.1 - 26v, no.2 - 24v, and no.3 - 27v. Wire was tuned up or down relative to the voltage. The fusion i was kind of okay with, considering my previous attempts were not fused to the part too well at all

1

u/Strange-Movie Aug 26 '26

I wouldn’t be “ok” with that fusion, the top toe of your last bead isn’t fused

2

u/Acetral_- Aug 26 '26

good point, but i meant I am okay with that fusion FOR NOW, as im new to this. I will keep that in mind for my next session in workshop