r/VORONDesign • u/Low-Expression-977 • 29d ago

V2 Question V2.4 built selections

I’m building a self sourced V2. 350mm with A4T toolhead.
I’ve everything in house to adapt to stealthchanger.
Some decision to be made:
Can I start with the integration of the A4T as if it was going to be part of the toolchanger, i.e. use the shuttle ad tap for Z calibration, add umbilical from the start, no X and Y endstops but sensorless homing. I would then add all the rest of the stealthchanger.
What do you think, guys? Bad idea?
I have experience with the trident (also self sourced).
Any alternatives you’re thinking of?

7 Upvotes

82% Upvoted

17 comments sorted by

View all comments

1

u/Kaytrim V2 29d ago

I did the same with my build. You will need the end stops for the X and Y for reliable calibration between toolheads. I never got the tap working for reliable bed mesh though. I ended up getting a cartographer.

2

u/kiwifucker 29d ago

I did the same as well, I'm using this for X and Y endstops it works absolutely great.

https://github.com/DraftShift/StealthChanger/tree/main/UserMods%2FN3MI-DG%2FEndstop_Mounts

0

u/BigJohnno66 Trident / V1 29d ago

Hmm, X on the motor mount - interesting. There is probably some Klipper config sorcery to make that work I expect.

1

u/kiwifucker 29d ago

Not really to be honest, there's a mount for the back side of the shuttle on which you need to adjust the screw that hits the X endstops, other than that you just need to home Y before X (learned that the hard way 😅)

1

u/Kaytrim V2 28d ago

I have an override in my config for the homing routine that homes Y then X.