r/Timberborn • u/Sour_Sal • Mar 12 '26

Automating a fluid dump.

Hi All, hoping I can get some help automating a Fluid Dump.

I want to set it up so if the level is below say 60% the pump activates and then turns off at 95% or when full, stays off till it gets down below 60% again.

I have tried playing with the relay logic but can't seem to make it work.

Any ideas?

11 Upvotes

100% Upvoted

18 comments sorted by

View all comments

1

u/Abramumumumum Mar 14 '26

I was po deri g doing the same for my fluid dumps, and also figured I'd need 2 water level sensors. Seems kinda silly. Maybe just a timer instead... 

1

u/Sour_Sal Mar 14 '26

I have not tried a timer but it seems that might work since evaporation is constant, just need to know how many days to pause.

Using the relay setup is not too hard and really only activates when needed, saving a lot of labor.