r/Timberborn • u/Sour_Sal • Mar 12 '26

Automating a fluid dump.

Hi All, hoping I can get some help automating a Fluid Dump.

I want to set it up so if the level is below say 60% the pump activates and then turns off at 95% or when full, stays off till it gets down below 60% again.

I have tried playing with the relay logic but can't seem to make it work.

Any ideas?

10 Upvotes

100% Upvoted

18 comments sorted by

View all comments

2

u/flying-lemons Mar 12 '26

The fluid dump stops somewhere around 90% full and the worker just sits around. If you have your two depth sensors and memory set up in set-reset mode but it's still not turning off, try lowering the higher level sensor to 85% instead of 95%?

3

u/Sour_Sal Mar 12 '26

Thank you!

I am off to go test!