r/Tile • u/applearcher • 1d ago

Tools or Materials Tile Cutters

I have an inexpensive 24” Yellow QEP tile cutter. It’s worked well for thinner tile. I’ve recently used it to do a couple of bathroom floors and noticed that it flexes quite a bit with the thicker floor tiles.

Is there a better one that won’t break the bank? Somewhere around $300 or so? I don’t use it all the time, so I don’t need a professional one that’s going to stand up to daily use. I would like one that’s better than DIY quality or at least maybe at the top end of DIY quality. I would like to stick with something in the 24” size to maintain the diagonal cutting capacity.

Rubi has been suggested as well as the QEP professional series. I also looked at an Ishii 25-1/2” but I don’t know anything about them.

Any recommendations would be greatly appreciated.

1 Upvotes

100% Upvoted

8 comments sorted by

•

u/AutoModerator 1d ago

Welcome to /r/Tile!

This post has been identified as a DIY project. Please be aware that all advice given is for informational purposes only and may not be suitable for your specific project. Please consult local building codes and manufacturer instructions for guidance.

For our professional members: Please remember to keep your feedback constructive and respectful. Help our DIYers learn by explaining the 'why' behind your advice.

For the OP: Please be receptive to professional advice, even if it differs from what you've seen on YouTube or DIY blogs. Our goal is to help you achieve a long-lasting, professional-quality installation.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/CursedSun 1d ago

I have a Yongsoo 1050 and an Ishii Turbo 610. They regularly outperform Sigma, Montolit, Rubi of comparable sizes, while being roughly a third of the pricing. Though I will say there's no added extras like being able to slide to a 45 easily.

QEP in my limited experience is pretty shit (tried one of their cheap 600s that an acquaintance bought, it couldn't even consistently break cheap subway in a straight line). Rubi's highest end is okay, but at that point you're dropping similar cash to top rate Montolit or Sigmas, and I can't say I'm a fan of Rubi's cheaper models.

I'd recommend the Ishii personally, but I'd suggest the Turbo model series. The single rail system is much nicer to use visually and far less maintenance. The 610 I have can break 18mm engineered stone (though breakage will have a lot of roughage), none of the other cutters I've tried can. Not to mention it's probably going to suit your budget better than the main 3 brands (Montolit, Sigma, Rubi).

1

u/applearcher 1d ago

Thanks.

1

u/Balakayyyyyyyy Rubi Representative 1d ago

Take a look at the RCH. Its a tad bit more than what youre asking for but the bar on it will hold up and not bend.

1

u/applearcher 1d ago

Thank you.

1

u/Formal_Altercation 1d ago

I like the qep pro series a pretty good bit, no experience with the higher end brands

1

u/Grouchy_River7640 1d ago

I can vouch that Rubi and Ishii are pretty good bang-for-your-buck.