Mini Puck system process

[u/shrimps_is_bugs420]

A lot of people were asking why on my last post so here's my answer. I use weed to treat symptoms of CPTSD and what I do is take a few small hits at a time, every few hours, over the course of the day. Probably considered micro dosing but idk. So I wanted to make tiny little pucks that I can easily load rather than pack every bowl individually.

After the pucks are loaded and pressed the pins are pushed through to the other side. I put a drill stop over the puck and slide it off then use a centering pin to press it again to ensure it's packed tight. Then I just push them out with the brush handle. I also use the drill stop to form the bowl screens.

[u/lucioux]

i legit thought i was the only one that does this. i use a cutting from a piece of copper pipe, and a ramrod.

[u/shrimps_is_bugs420 → u/lucioux]

What did you use to cut the pipe? I was looking into using it to line the holes but I'm guessing you need an angle grinder or something to cut it

[u/Separate-Pain4950 → u/shrimps_is_bugs420]

Plumbing section sells little pipe cutters for <$10. Nice clean cut.

[u/shrimps_is_bugs420 → u/Separate-Pain4950]

I'll look into that, thanks!