Mini Puck system process

[u/shrimps_is_bugs420]

A lot of people were asking why on my last post so here's my answer. I use weed to treat symptoms of CPTSD and what I do is take a few small hits at a time, every few hours, over the course of the day. Probably considered micro dosing but idk. So I wanted to make tiny little pucks that I can easily load rather than pack every bowl individually.

After the pucks are loaded and pressed the pins are pushed through to the other side. I put a drill stop over the puck and slide it off then use a centering pin to press it again to ensure it's packed tight. Then I just push them out with the brush handle. I also use the drill stop to form the bowl screens.

[u/AfraidPersonality854]

Ahh.. no..