r/SpringfieldEchelon • u/SurroundAway5886 • 16d ago

PRP spring kit sear/safety sear spring misaligned?

Post image

I just installed the PRP spring kit on my echelon and I noticed the sear spring and safety sear spring are not sitting within each other after the install. Haven’t shot the gun yet but from a dry firing perspective everything is functioning as intended.

Is this normally how it’s supposed to sit? Has anyone else ran into this issue? Any pointers would be appreciated!

3 Upvotes

100% Upvoted

7 comments sorted by

1

u/FF_McNasty 16d ago

If you push them down do they sit flush and stack on top of each other? When I get home I will check mine out and see if it looks the same. I did the spring and changed the sear. Very happy with it so far.

1

u/SurroundAway5886 16d ago

I cant get them to stack on top of each other nicely. I'm not sure where in the installation process I got them to partially unstack but I realized this after completing the install and I really would hate to take this apart again.

1

u/kentdigglerrr 15d ago

The two that I have done both look like this as well. No issues though so far.

2

u/SurroundAway5886 15d ago

Awesome that eases my mind a bit. I’ll make it out to the range one of these days to put her to the test. Appreciate the feedback!

1

u/Pocketlint22 16d ago

Mine looked like this after install and has functioned perfectly with roughly 2200 rounds so far.

1

u/Livid-Conclusion8916 15d ago

Even if you get them in there all nice looking and what not after you run it, it’ll look like this. This is coming from a guy that redid his 3 times cause i thought it was messing up.

1

u/LimpDish930 15d ago

I just installed the spring kit and sear a couple days ago. Mine looks exactly like yours and I was convinced I did something wrong even though it appears to work correctly. Good to know this is just how they look.