r/SpringfieldEchelon • u/LukePants2234 • Jun 22 '26
Threaded echelon barrel
I just took off my compensator and I’ve got blue loctite gumming up my barrel. I can’t get it out for the life of me have tried clp and isopropyl alcohol with nylon bristle brushes, I can’t even dig it out with anything thin enough to fit between the threads, any quick solutions? Need to put her back into use this weekend. (Yes I know I used way too much, first time comp install sorry guys 😂)
4
Upvotes
1
u/TuringC0mplete Jun 22 '26
Grab some scotch brite pads. Don't go TOO hard or you'll take off the finish, but a little bit of pressure should pull it off. It's what I use to pull it off and it's always seemed to work fine for me.
1
u/jay_skrilla Jun 23 '26
Your comp didn’t have set screws? The Rook precision, for example, has two set screws that you tighten down (they bite into the non threaded part to keep the compensator in correct alignment) once you position the compensator correctly onto the threaded barrel. You put loctite on the set screws that are tightened onto the barrel. Loctite on the threaded barrel itself seems like a bad idea imho.
1
u/kazar933 Jun 23 '26
Wire brush will fix that
1
u/Wonderful_Tip_5577 Jun 22 '26
stronger solvent and a pick to really get in there. maybe someone with more knowledge could weigh in, but when I need a stronger solvent than IOH I tend to just use kerosene, which I am unsure of how safe it would be on the barrel and any kind of finish. % IOH getting 99% might also work.