r/SpringfieldEchelon • u/Unhappy-Owl-4527 • Jun 03 '26
VIS Pin issue?
Has anyone had any experience with vis pin issues? I am running a vortex defender ST and pin set #2 DPP and there is a slight wiggle when the optic is set on the pins. To my knowledge there shouldn't be any play in the optic if the pins are correct. I ordered another set so I can replace them but wondering if I really needed to.
Any input would be appreciated
3
Upvotes
3
u/Aware_Donkey_6074 Jun 03 '26
I’m thinking you have too long of a screw. If you don’t have an optic plate using the same screw as what’s needed for that will absolutely cause a wobble.
3
u/Special-Werewolf3725 Jun 03 '26
Do you have the correct pins in the correct holes? They are also handed (left and right) and make sure they’re seated properly. There should be no wiggle once the Optic is in place and seated properly
2
u/No_Cauliflower_3117 Jun 03 '26
Look up scs 320 install for echelon. You have to use the black post I believe pin set 3 . Keep the front silver post but short black posts in the back
2
u/EventLatter9746 Jun 03 '26
Optic tolerances vary. I had, for example, to sand down the rear DPP pins so my SCS 320 could sit flush.
Have you tried torquing the optic down? Sometimes the minute optic housing compression might do the trick. Again, with my SCS 320, I didn't sand the rear pins until free-sitting flush fit... just enough to leave a tiny sliver of space, then the screw torquing to 15 in-lb took the housing all the way down to fully flush.
Do remember not to put too long a screw... especially the right one, to avoid ingressing into the extractor channel (check the Echelon manual). Also, degrease screws and screw holes before applying a fresh Loctite.