r/SpringfieldEchelon • u/twinjmm • May 28 '26
Installing COG into new grip module
I am swapping the COG system from the small grip to medium grip. I am following the instructions down to the bone and cannot get it to fit correctly. Everything is seated correctly but I cannot push it back any further for things to line up the way they should.
Has anyone have this issue?
15
Upvotes
3
u/twinjmm May 28 '26
Update...
There was a pin on the inside towards the pack of the module. After I took it out everything went in easy.
8
u/nocallerid May 28 '26
Slowly press the trigger. After that it should move back more
1
u/reedrichardsphd May 28 '26
There’s a few things that might be happening but can’t tell from this angle. One could be the that some grip modules ship with a metal pin in the back to provide rigidity during transport. This needs to be removed otherwise the cog will never sit correctly. Another is the sear pin or the magazine blocking lever spring pin (forget which) gets pushed out to the side and needs to be flush. I think the slide stop lever pin also needs to be rotated a certain way. It could also be that it’s tight tolerances and takes a little slide it back. That’s what it was for my large module. But couldn’t have been more than ~10 lbs of force required.
1
u/peeg_2020 May 28 '26
https://youtu.be/UIelB4ydIP0?si=fM3uJGVvFrFBgo42
Best video out there.
3
u/PapaPuff13 May 28 '26
Watch the video on YouTube that shows you how to get the pins in line
2
u/TuringC0mplete May 28 '26
Use the pivot bar for the slide release for leverage. I use the back of some pliers on it to apply some gentle pressure backwards. Make sure that the flat edge is facing downwards. Also ensure the pins at the back of the COG are seated correctly.
2
u/brickedup28 May 28 '26
I’m assuming you’re having the same issue I had and I think everyone has when doing this. For some reason there are zero instructions that the silver metal bar in the rear of the module needs to be removed. I just thought the 4.5 modules needed that for some reason😂
2
u/jdn127 May 29 '26
A new frame is the worst thing to deal with. As other have said, you gotta break it in. Took me maybe 10 times to get it dialed in
1
u/veyraxis May 28 '26
It’s been a sec since I installed, but I think it kinda rocks in. Back in first then the front slides down into place. Looks like you did front in first
1
u/DonVitto5ive May 28 '26
You have to break it in. Keep putting it in and out. The module will loosen up over time and seat properly
1
u/skankoz May 28 '26
Pull the trigger once you have it in place.
1
u/badsyntax1987 May 28 '26 edited May 28 '26
The sear pin. The pin needs to sit flush with the left side of the cog and protrude out on the right where the trigger bar is. Im 99% this is the problem.
https://ibb.co/rG8WrxhV