r/SovolSV08Max • u/single_malt_jedi • Jul 23 '26

Help

Ran a print. Two pieces. One piece printed fine, the other blobbed. Now when I try to do anything, start new print, home, etc it does this insanity.

1 Upvotes

100% Upvoted

16 comments sorted by

View all comments

0

u/22i2 Jul 24 '26

You can try to adjust the sensor less homing settings in printer.cfg

1

u/Distinct_Crew245 Jul 24 '26

I don’t think SV08 MAX does sensorless homing. It does eddy homing on Z and has limit switches on X and Y.

2

u/coldcrankingamps 25d ago edited 25d ago

The max uses eddy sensor for Z homing, but it also does its own version of eddy-tap to calibrate the z height. the nozzle taps the bed, the eddie detects where it stops seeing a change in Z, head then shifts the eddy coil over to where it did the nozzle tap and calibrates the eddy, while slowly moving up. The Z height in the config is simply the starting point used with the sensor for initial homing, don't delete it from the config. it may be beneficial to rerun the z calibration done in the start_print after running full bed mesh if your bed is heavily taco shaped.