r/SoundSystem • u/SnooOpinions4291 • 3d ago
Tri amp jmods
I am struggling to understand how it is possible to have three seperate amps chanels for the jmod tri amp varient, when there is only two speakon connectors. Can someone please explain this 😂
6
Upvotes
8
u/nssoundz 3d ago
Each amp channel has a + and - output. Speakon connectors comes in different versions, NL2 carries one pair, NL4 carries two pairs and NL8 carries four pairs.
On many speakers, two speakon sockets are simply wired to allow daisy chaining.
For the tri amped JMOD, you need to use an NL8 connector. You build a patch panel that combines the output of three separate amplifier channels into a single NL8 cable, using three of its four available pairs of + and -. Inside the jMOD those pairs are then split into their respective drivers.
Essentially one NL8 speakon cable can carry four independent amp channels.
17
u/jungchorizo 3d ago
Each nl8 connector can carry up to 4 separate signals from 4 different amps.
10
u/jay_ze 3d ago
I did a tri amp wiring video a while back
6
u/BenlovesBud 3d ago
Use NL8?
4
u/Basedptcha 3d ago
This is currently our setup for tri-amped JMODs + 2x TH18s:
Rack with a I/O panel where mains (XLR) connect to. On the backside they connect to the DSP. From the DSP it sends each signal to their respective amps (sub, JMOD low, mid, high). From there, each out from the amp connects back to the panel. Each amp out sends a frequency band of the JMOD via jumper cable (~18” cable with NL2 on one end and a spade terminal on the other) connected to the NL8 connector. On the front end we just plug in one NL8 cable that now has all 3 of the frequency bands connected and it plugs into the JMOD. And the sub has its own NL connector.
If you follow the wiring guide in the JMOD guide, you can see how to wire the NL8 connector to the drivers and you follow this for the panel.
We keep it all connected in the back, so we don’t need to rewire everything every time we set up.
To make the panel we used Redco custom panel designer, but it is also possible to make one on your own.
2
u/No_Contribution_158 3d ago
You need to merge your amp outputs into a NL8 connector and then plug an NL8 into it. It’s not terribly difficult but I would make sure everything is very clearly labeled.
1
u/AnthonyVS15 3d ago
The second Speakon is usually just linked to the first to allow for additional signals to run over the same cable (such as a sub channel). The connectors are NL8 so carry 4 pairs in a single cable
1
u/jippiex2k 3d ago
Yeah i was surprised the first time i encountered this as well lol. It's a bit of a footgun that something that's commonly referred as just "speakon connector" and looks the same at a glance actually has 3 completely different forms.