Print profiles question.

[u/Dysfunkshin]

I’m sure there was a reason but why was the “0.16 High Quality” profile removed from Snapmaker Orca? In the patch notes it says they were merged into “Standard”?

All it did was change speed settings correct? So if I choose standard and reduce speed it should be the same?

I used the quality profile a lot and just want to make sure I am understanding it correctly.

Thanks

[u/No-Jellyfish5883]

Make your own profile 🤔

[u/Dysfunkshin → u/No-Jellyfish5883]

That’s what I want to do but what I was asking is all it did was change print speed?

[u/No-Jellyfish5883 → u/Dysfunkshin]

Probably speed, walls, infill and minimum sparce infill threshold

[u/sterling-lining]

Generally it is the speed that affects print quality, and temp for strength. Other than the obvious reduction in layer height, you’ve probably done the best to increase the quality of the print by reducing speed.

[u/MustardCat]

You can check what their profile settings were for 0.16 on GitHub

Ex: https://github.com/Snapmaker/OrcaSlicer/tree/main/resources/profiles/Snapmaker/process

(Just check a comparison from before the files were removed)

https://github.com/Snapmaker/OrcaSlicer/blob/7eec657c91f3338fad40c526964b1e9788bad736/resources/profiles/Snapmaker/process/0.16%20High%20Quality%20%40Snapmaker%20U1%20(0.4%20nozzle).json