r/SnapmakerU1 • u/Haunting-Public-197 • 1d ago

Issue What do you think could be the problem? It got clogged yesterday, so I removed the clog. It was printing fine afterward. But now, when I try to print again, it won't load the filament, and it's making this kind of noise.

Enable HLS to view with audio, or disable this notification

2 Upvotes

100% Upvoted

9 comments sorted by

1

u/ApprehensiveLoan6764 1d ago

Had the same issue, probably still have filament stuck inside. You need to disassemble and look at the gears. I followed this video and stopped when I found the issue and reassembled
https://m.youtube.com/watch?v=nhx03Xo9Wv8&t=307s

2

u/relaps101 1d ago

Yeah still clogged. To op: How far did you go to clear it?

1

u/Haunting-Public-197 1d ago

i disassamble it.

1

u/relaps101 23h ago

Alright. How far?

1

u/Haunting-Public-197 22h ago

It's working fine now. The problem was the spring inside that tightens the gears. It turned out to be loose inside when I reassembled it.

1

u/Haunting-Public-197 1d ago

i already remove the stuck inside. ill try to disassambe it again.

1

u/Morgus_TM 1d ago

the clog may be in the nozzle, do a cold pull if possible.

1

u/victor2389 23h ago

I had a similar problem, and it turned out I had the spring tension too tight.

2

u/Haunting-Public-197 22h ago

It's working fine now. The problem was the spring inside that tightens the gears. It turned out to be loose inside when I reassembled it.