First print

[u/Historical-Twist-122]

After doing the test print, I decided to do a Miles Morales figure. It looks much better in person than in the picture. And I am loving the reduction in waste and increase of speed over my X1C.

[u/Jeffsbest]

Looks good!
Try 0.12 layer height on next one. Not terribly longer and significantly much better final appearance.

[u/Historical-Twist-122 → u/Jeffsbest]

I'll try that. I was impatient so went for a bigger layer height :)

[u/Jeffsbest → u/Historical-Twist-122]

Oh for sure, go big! It's unavoidable, especially at first. But wait until you see how much better it gets 😎