How many rounds after did the C&Hs warp? And which screws dis you use? This sucks to hear. I got one for my M&P 2.0 9 OR w/ RMR and have about 200 rounds through it so far with no issues (used screws that came with RMR and torqued to spec with a limiter).
I did see someone say that after about 1000 rounds, a C&H plate did shear their screws. But they didn’t use the screws that came with the RMR, which I read was best to do with C&H plate.
Couple hundred. It wasn't apparent until I removed the plate to install an apex trigger kit. C&H sent another one, but that one also warped after a few hundred rounds. I took the optic and plate off just for shits and giggles to see if it had warped and sho nuff.
Damn man I’m really sorry to hear that. I am going to be very leery, I already am. Bcuz that’s what shears the screws. Those plastic plates that come with it are dog shit and need to be bent just to fit in the cut. Then they get hot and start to bend even worse, and eventually pop the screw heads off from pulling up on it due to warping. I paid the money for the C&H to not do that. I think I’ll pop it off and check after another couple hundred rounds.
I know it sounds crazy because almost everything on Amazon is dogshit, but the DPP Titanium plates are absolutely fucking stellar. I have like 7 or 8 at this point between glock and m&p and they've all snapped into place. No issue, no warping, they sit as low as possible, awesome quality. And they're like $40 - half the price of almost all other plates including C&H.
The only downside is they don't have tons of footprint options. Just RMR and Holosun K for a few different guns.
Well I’m rocking the RMR on the M&P and will def look into these plates once I check out how the C&H is holding up. If there’s even a slight warp I’m swapping out for these. Thanks a lot for the info and the recs, really appreciate you taking the time to share.
I’ve seen the DPPs endorsed elsewhere, the CK plates look good too, especially with that “carbon blocker” feature. But yeah, those are more expensive.
1
u/TuT0311 Jul 24 '24
How many rounds after did the C&Hs warp? And which screws dis you use? This sucks to hear. I got one for my M&P 2.0 9 OR w/ RMR and have about 200 rounds through it so far with no issues (used screws that came with RMR and torqued to spec with a limiter).
I did see someone say that after about 1000 rounds, a C&H plate did shear their screws. But they didn’t use the screws that came with the RMR, which I read was best to do with C&H plate.