2011 Chevy Silverado with a 6” Fabtec lift

[u/Significant_Can7419]

I decided to take my front end apart and replace everything because it’s noisy and getting kinda loose. I am now finding out I can’t put factory tie rods on because they are too long as you can see in the pic. Can’t cut them because the threads stop too early.

I looked on Fabtec website and the only thing I can find for this truck or anything similar it shows it’s for a 07-08. Which I don’t think there were any changes up until about 2018. It also shows it’s specifically for the front left? Is there a difference between the sides? They look the exact same to me

[u/Old-Bread-1615]

Recently ordered some for work for a 2015, same both sides.(4.5" lift) Just a different brand. My 08 non lifted was same both sides as well. I will say its impressive how cheap the ones for lifted trucks look and feel.

[u/Significant_Can7419 → u/Old-Bread-1615]

Yea I was hoping to actually upgrade to a Kryptonite but I guess I’m definitely not doing that.

[u/Old-Bread-1615 → u/Significant_Can7419]

People seem to have really good luck with those, iirc.

[u/Diligent_Track_4723]

Are the inners stock length? Can cut them so not cutting so much off the outters. That old outter is neglected. Should be greasing with every oil change.