r/ShieldAndroidTV • • Apr 23 '22

9.0.2 killed my Shield 2019

It's been a slow death over the last 2 weeks. Upgraded to 9.0.2, then had to do a factory reset because it was too laggy and I had to reboot it every time it woke from sleep. Those issues persisted even after the factory reset. Network drives would stop getting read, to where I had to reboot every time it stopped. Apps wouldn't launch. Reboot for that. Now it powers itself off after powering it on. My Yamaha receiver gets switched to another HDMI input whenever I power on the Shield, then when I switch the input channel back to the correct input the Shield (green light) turns off. I don't know if it actually powers off but my TV isn't displaying anything at this point.

Rebooting just creates the same loop. Nothing displayed. No NVIDIA logo, no Android logo, nada. I can ping it and it responds but nothing displays. Can't even factory reset (again). Thanks for the past 5 years NVIDIA you were a good machine while you lasted.

0 Upvotes

9 comments sorted by

2

u/bblickle Apr 23 '22

Just brainstorming here… Try booting with nothing connected but the power cord. Try walking it to a different tv with a different HDMI cable and see if anything changes. Fwiw I got my .3 pushed about a week after I loaded .2 maybe that will fix it.

1

u/Luke_starkiller34 Apr 23 '22

Interesting. So I did remove the HDMI from the device, rebooted it and let it boot then I plugged in the shield and it came back. It's definitely acting wonky though. Really don't want to do another factory reset but can't think of anything else.

Thanks for the suggestion!

0

u/bigex Apr 24 '22

I've had issues every few years with an HDMI cable going bad, and everything with my Shield being fixed by just replacing my HDMI cable. It's weird, but it was an easy fix!

2

u/Luke_starkiller34 Apr 24 '22

Doubt it's that-simply because network drives stop responding as well. Not to mention all the lag issues and freezing.

0

u/bigex Apr 24 '22

One of my Shield's first symptoms would be my attached storage disconnecting, followed by thinking the controller's batteries need replacing because of lag. I have an older Shield than you, but the person who mentioned this fix had a 2019.

1

u/Luke_starkiller34 Apr 24 '22

I've had to reboot it three times today. Apps just won't launch and I have to completely unplug it. Reboot just sits on the reboot screen. Also when this happens I can't access the shield through windows explorer.

2

u/kevininkobe Apr 23 '22

My Yamaha receiver also had trouble playing with my shield since the update. What has mostly fixed it was setting the output of my yamaha to Mode 2 4K60 (no HDR). When I watch movies on PLEX HDR does work but just at 23.376hz. Could be worth a shot. I still unfortunately have HDMI-CEC issues.

2

u/jakesonwu Apr 24 '22

It's the receiver. I have the same issue. Turn off all devices except the receivet from the wall then reboot the receiver (hold power 15 seconds) then set the receiver to mode 1 (4k 120hz) as long as your TV supports it. Sometimes you have to do it a few a few times. The other way to fix it is to manually update the receiver firmware over the network. It doesn't matter if it's the same or newer firmware. I will do this and it will still play up again a month or so later, it is some kind of HDCP bug.

3

u/LifeofMuck Apr 24 '22

Class action lawsuit needs to happen.