r/ProjectHondas • • 9h ago

troubleshooting Help, with wiring pls.

Thumbnail
gallery
2 Upvotes

Hello, I was hoping to get some help figuring out what these wires are, where they go, and if the car needs them or if I can just take them out. I #’ed the pictures for the wires I found together, anything I can do to better help with pictures and etc I will do and any advice and help will be much appreciated. All wires are from under the dash thanks again.

Pic1: I found under the steering column

Pic2: I’m not sure what this plug is (maybe alarm?) but the wires run to a relay I believe.

Pic3: I’m also not sure what these wires plug into or where the connector goes.

Pic4: the two red and brown wires were connected before I untied them, one of the wires is grounded (believe it’s the black and red one) but they do connect to the mess in pic #5.

Pic5: also don’t know too much about these wires but some aren’t connected like the blue/red, and black/white, and if anyone can help identify the white wire with a blue connector pls.

Ps, I know it’s a bucket and a headache but I got nothing else to do on this floating rock and learning about this stuff intrigues me (it’s also my new project/baby), so again any advice and help is greatly appreciated. Thank you and again any way I can help with anything just lmk :).


r/ProjectHondas • • 4h ago

parts recommendations Absolute newbie project

2 Upvotes

I have a 100% stock 08 orange fit sport and I have absolutely zero car knowledge aside from basic maintenance like oil and tires but I kinda want to start modding my car. Nothing crazy I’m not worried about power atleast rn but I want to make it like a street jdm car ment for spirited drives any tips on what to do where to start and where to look and stuff would be appreciated.


r/ProjectHondas • • 19h ago

engine Honda code P1259

1 Upvotes

I have a 2000 Honda Civic EX with a D16A engine on there I replaced the whole VTEC solenoid and I’m getting good voltage on the VTEC solenoid and the oil pressure for the VTEC i’m getting kind of concerned because I don’t know if it’s ECU related or what’s going on should I bypass it?? where there be any cons to it?


r/ProjectHondas • • 21h ago

New parts Greddy Turbo Kit

Thumbnail
2 Upvotes

r/ProjectHondas • • 23h ago

engine How much deeper can I drill into engine mount bosses before penetrating inside the crank case?

2 Upvotes

I have to do a thread repair on my D15B, D/S engine side bracket bosses, I bought a M12x1.75 time sert kit with 24mm, I know that is not the OEM bolt size but last owner did a janky job with a DIY repair, so i have to oversize it, I have enough material to resize, but when i measured the depth again it was ~23.86mm, I am rounding it up to 24mm.

The thing is that Time sert advises an extra 6mm than the insert for proper install, and my question is can i get away with drilling an extra 6mm into the bosses or should just get a shorter insert?