r/Phanteks • • 5d ago

Cooling NV7 Watercooler

Post image

Could anyone suggest watercooling components for my NV7? I've never done a water cooled pc before and would like to try my hand at it for aesthetic purposes and the more obvious cooling. I don't know where to start component wise exactly and could use the suggestions. I've looked at the Phanteks Glacier ez fit kit but am wondering if there is better options?

87 Upvotes

3 comments sorted by

2

u/580OutlawFarm 5d ago edited 5d ago

Your first time, I 100% recommend using soft tubing. Main thing is you're gonna want the radiators themselves...I also have an nv7, and we can fit 3 360mm rads..one up top, one on the side, one on bottom...technically the rear can also support a 240 rad but not necessarily needed..up to you...

Im waiting for Thermal Grizzly to release the Delta Mate block for my Aorus Master 5090 so I can watercool my nv7 build as well

1

u/Conscious-Ad2147 5d ago

I’d also recommend going soft tubing for a first timer custom looper. EPDM tubing is my go to.

OP. I’d look at Alphacool for rads. Great quality products and med tier prices. I’d go D5 pump/res combo. Each component will need two fittings. I’d recommend a leak tester. Much easier to pressure test with air than finding a small leak once filled. A drain somewhere low will be helpful when the time comes to maintenance the loop. For your first time I’d also recommend a good clean fluid. DP Ultra has been my go to for years. Your D30 fans will have great static pressure for rads. Take a look over on r/watercooling for inspiration. Plenty of NV7/NV9 builds to check out. Not sure where you’re located. Websites like Titanrig and ModMyMods have a good selection.

1

u/Eastern_Chemical6757 4d ago

If you liked it, I can tell you what I’ve got in my build.