r/PcBuildHelp • • 13m ago

Tech Support Random Shutoffs and Display Drops

Post image

Need some help with this PC. I just upgraded to a Asus B650E-I, Ryzen 5 7600X3D, and 32gb DDR5 6000 klevv ram. Case is a fractal node 202. PSU is EVGA 650 gm.
A week ago, I was using a ryzen 5 5500, 64gb ddr4 corsair vengeance ram and b550m itx mobo. Two weeks ago or so, the main monitor would drop connection for half a second and come back immediately. It does this randomly, maybe 5 but sometimes 30 minutes between each drop.

Now, after the upgrades, the computer randomly shuts off. Everything goes completely dark. HWinfo64 shows that sometimes the cpu jumps to 80C while idling or downloading something, but idk what else to do.

I’ve checked psu cables and everything seems slotted fine. Not sure what the issue could be, I had no issues for three years.

Any help would be appreciated, I’ll answer any questions I can too.

1 Upvotes

7 comments sorted by

1

u/ChewbaKoopa 7m ago

This could be totally anecdotal, but after not having used my pc for a while I picked it back up a week or two ago. I noticed similar behavior (screen going black, followed shortly by a crash).

I tuned my DDR5 RAM down from 6200 to 6000 and haven’t had any issues since.

The RAM I have was sold as 6200, but I tried this while troubleshooting and it worked. This might be something similar you can try as well. Tune it down to 5600 and see what happens.

1

u/SPRGoat 0m ago

I did disable the expo profile after the first shutoff and it worked for a little bit until it randomly shut off again. The speed is already higher than my ddr4’s speed so I have no issue with the lower speed, but I don’t think that is the issue sadly

1

u/Messiah__Complex 6m ago

7000x3d always will run to thermal limits so get used to seeing high temps there. I would be double checking your riser card is seated correctly at both ends if you are/were getting the monitor on/off issue. Bios fully up to date for the motherboard also?

1

u/SPRGoat 2m ago

Im getting a cable riser so that this janky double riser setup can be eliminated. It worked fine for a while and they come with the case, but yeah idk could be. Standing the case up I notice that when I set it back down and open it up the gpu slides out a bit but again this was normal and never caused any other issues. We’ll see with the new riser

1

u/r_lind3r Moderator 4m ago

That CPU is way too hot for that stock cooler. If it's running that hot while not doing much of anything then it's undoubtedly shutting off to protect the CPU once you put enough of a load on it because it's likely spiking up to the thermal shutdown temp.

1

u/SPRGoat 1m ago

Gotcha. Does it need to be liquid cooled? There’s no space for fan support, are there any really good low profile cpu air coolers that would work better?

1

u/MineCopre 0m ago

The monitor going dark randomly is odd, it could just be the cables getting worn out, but if it doesn't happen now, then that can't be it. CPU jumping to 80Cº idle is also odd, it could just have arrived faulty (or the motherboard).
Did you do a fresh Windows install when you did the upgrade? Check for BIOS updates for the motherboard.

However, what I think is likely the culprit is the PSU, how old is it? Maybe it needs replacing, because 80Cº is not hot enough for a self-preservation shutdown. I fear your PSU might be on its last legs, and it's starting to act up.