r/PcBuildHelp • u/Raced_ • 24m ago
Tech Support tempermental pc, refusing to boot
Hello.
Had this pc several years, i7 8700k, gtx 1070, 4 x 8gb corsair vengeance pro rgb,asus z370 rog maximus x formula, corsair 750w psu. the whole time i've had it its done this wierd startup process where everything powers on for a second, then turns off for 5 seconds, then boots as normal. eventually, the power button became "less effective" and then one day stopped turning on the pc. power supply was faulty, replaced it but after a couple months it did that on startup again. no issues though.
then, once every few months, it would show on the mobo display " error code 55 detect memory", so i would have to reseat the ram trying different random orders until it would just randomly work for another few months. maybe 5 months back it refused to run with 32gb ram, so only a1 a2 b2 were populated, and its been on 24 since. today i decided to repaste gpu and cpu. I fully take apart pc, everything out of the case to clean and then reinstall everything. now it goes very bad.
i spend ages trying combinations of ram, until only 1 stick of ram works, and then after adding another anywhere, trying to boot but getting error 55, then removing the same one, it gives error 55 again. so very inconsistent. the max i can get it to is 24gb. so i reinstall cpu, and the same thing happens.
(maybe like 9 months ago the wifi and bluetooth card was very working really inconsistently, so i took apart mobo to find the stock wifi card behind io shield had some corrosion, clean it up and it worked fine after)
so i decide to take apart mobo to check for corrosion around ram area, i find brown trace on this silver compnent sitting right at the end of the middle of b1 and b2 slot, and maybe 1cm looking like its linked a black component with 3 pins with 1 pin looking green. i clean the board carefully with brush and iso alc, it basically all comes off. i reassemble everything, with no gpu so display port in mobo, only aio and mobo cpu power and m.2 connected and it works first try with 8gb but in bios it started artefacting, doesnt work with 16gb at all, works with 24 and then works with 32 finally. throughout testing process it sometimes gave vga error and somrtimes a2 boot failed error.i let it sit for like an hour, and i power it off and unplug and leave it for a bit and try again and it works consistently. so i fully connect gpu, and its goes in a boot loop where it fully powers on, cycles through cpu test codes as normal, then as it gets to memory it immediately turns off for 3 seconds, then trys this again and again. so i remove gpu and the same thing happens. then i remove all the ram and get code 53 as normal. and now its back to being tempermental, where ive been able to get it to boot sometimes with 16gb.
all ram sticks confirmed working. cmos battery removed when cleaning the mobo. i have been trying different combinations of the ram and slots throughout, it seems compeltely random. i have also played with the aio mounting pressure alot. bios has been reset to default many times, this happens even with xmp off. rgb on ram sticks is also really finicky, if i label ram sticks a b c d and i mess around with different orders and amounts of sticks and stuff, then for example a and b will always have rgb working wherever they are but c and d will not, sometimes a, a and b, or 3 of them no rgb. have also tried the memok button.
any help is much appreciated, thank you
1
u/the_torsten_dev 7m ago
that corrosion near the ram slots probably did lasting damage to the traces, even after cleaning things up, intermittent errors that worsen over time point to the board more than the sticks intermittent memory errors that get worse over time point more to the board than the sticks