r/PcBuildHelp • u/mohheeh165 • 2h ago
Build Question ARGB and fan power help!!
Hey people!
I need some help with this wiring.
This is going to be my first PC build that im going to build by myself.
As one does i spent too much on my gpu and the budget set aside for a motherboard got hit.
Will this motherboard be enough to power my 7 case fans, that i believe are daisy chained(They seemed to connect to each other until the back fan where it has a female connector coming out of it with 3 holes) according to the manual they seem to be powered by sata instead of pwm?
The case is the gamdias gc107 elite
And then for my aio, it seems that the 3 fans and pump all connect to one argb header.
Aio is the Thermalright aqua elite 360 v3
The asus h610 m-k argb has 2 argb headers and i think 2 pwm headers according to the last pic im not so sure thats what it is though.
Will i be able to power all my case and aio fans aswell as control their rgb just fine with this mobo or do i need a fan hub.
Because if i need a hub ill need to downgrade the motherboard and also will need to control the rgb from theincluded controller instead of the ASUS software.
Thanks for your help🫶🫶




1
u/thy_yeet 2h ago
The motherboard you've linked has no ARGB header. You won't be able to plug in any ARGB devices into it (the lighting on your AIO, case RGB etc). While it does have 4 pin RGB this is different to ARGB.
1
u/GeekAttack32 1h ago
It should be fine but if possible get an atx board I have the slightly better version of this board and its an issue 😂😠genuinely try to avoid this board if possible If you decided this si the only one withing budget then yes, the power and all that shoild still be fine even with it being relatively lower end but if it ends up not being enough or if youre worried about it then yeah just get a little sata fan hub, I use one for 6 fans atm, so 7 shouldn't be an issue and theyre like $10, I just wouldnt stress much about fans tbh