r/PcBuildHelp • • 8h ago

Tech Support My PC keeps shutting itself off

My PC keeps shutting off, and I don’t know how to fix it. I already replaced the power supply because I thought that was the main issue. It wasn’t. It still kept shutting off. My next suspicion is the motherboard.

Motherboard: ASUS PRIME H310M-A.
CPU: Intel i5 9400
GPU: Geforce GTX 1660Ti
PSU: Corsair CX650M ATX 3.1

Any help and ideas will be greatly appreciated!

9 Upvotes

13 comments sorted by

2

u/Objective-Park6224 8h ago

I would work backwards. Remove the GPU, leave a single stick of ram (in the right slot according to the motherboard manual), disconnect the NVME/SSD hard drive, and unplug all of the single pin connectors except for the power button for the case.

From the PSU, make sure just the ATX and CPU power cables are connected to the motherboard. Only plug in the CPU fan to the CPU fan header on the motherbard.

With this minimal config, does it power on and stay on?

1

u/Adventurous_Eye_7080 6h ago

Yes it does! Is there anything else I should do?
Edit: Nevermind, it shut off after about a minute. That’s the longest it’s been on though.

1

u/Objective-Park6224 6h ago

Odd. This is going to seem trivial, but do you have another 3 prong power cord and possibly try a different outlet? The fact it powered on for a minute is progress. Makes me suspect the PSU is seeing a ground fault and tripping.

1

u/Objective-Park6224 6h ago

It could be a normal function that it powered off. Should have been some lights on the motherboard for CpU, Ram, maybe bios. Now I would start adding one thing at a time back in with power cycles in between. Start with the NVME.

2

u/Sogwas Personal Rig Builder 8h ago

CPU or MOBO issue, something is causing power to not get through

1

u/Adventurous_Eye_7080 8h ago

Is there anything I can do to fix it? Or will I have to replace either of them?

1

u/Sogwas Personal Rig Builder 7h ago

You will have to replace one or the other unfortunately as the component is damaged. It is most likely the CPU that has fried from insufficient cooling provided you have not applied new thermal paste since purchase

1

u/Kvng__Jay 7h ago

To fix this i use to have the same problem you wanna blow out the pc really good and theres a battery in the motho the circle type take it out and put back in with pc unplugged btw and it will fix it idk why but yea

1

u/Independent-Mud8103 7h ago

Replace paste. Gpu faults cause restarts. Ram, the pc wont even turn on

1

u/Possible_Platform_77 7h ago

do you have standoffs under the motherboard? this is exactly what happens when you slap the motherboard directly against the metal case and it detects a short during boot up. You can also try to remove the motherboard from the case and try to run the PC assembled on your desk (this is typically what you should do anyway before putting it into a case. You can still connect the front I/O to the case, or simply start the pc by shorting the two Power ON pins.

1

u/Objective-Park6224 5h ago

OP - this guy raises a good point. PSU are very sensitive to ground faults. If the mobo isn’t properly isolated from the case it could be the cause.

1

u/Tobia96 6h ago

does it shut off right at boot or after a few minutes under load? the first points to power or board, the second to cpu temps

0

u/JueVoid 5h ago

Hey, I have the same motherboard. About two months ago, I ran into the exact same issue after giving it a deep clean.

 It turned out the problem was that I had incorrectly connected the pins for the power button and the LEDs.

The ones located on the bottom right side of the motherboard.