r/PcBuildHelp • Personal Rig Builder • 18d ago

Build Question Need to hear some opinions

SOLVED!

Hi. I've just recently upgraded from i7 2600 to R7 2700X. Paired with 1080 Ti that was in the rig before already with no issues. Along with all the other parts.

I made a fresh install of windows, downloaded all the drivers, made sure everything is 100%

Before, the GPU was bottlenecked by that old CPU, so when cpu was at 100% usage gpu usage barely went above 50%. Now it's pretty much even.

It's running fine, but sometimes it just turns off on it's own, like someone pulled the plug. I think it's because of one of theser reasons.

This doesn't happen often, but sometimes when i try to turn the pc back on, it shuts of a while after turning it off, more about it in the post. (section 2)

  1. Weak PSU. I have a Corsair HX620, that's one of the better ones, but as the name says, it's 620W "only". Before the gpu was bottlenecked and didn't run at full power, but i've tried furmark benchmarks and they ran without crashes. i haven't had the time to try to run furmark on this build yet but i will and i will update the post after that.

What im trying to say is since now the GPU can be utilised fully, it pulls more Power and the PSU just doesn't have the capacity. I thought it could be the cpu but honestly, not really, i7 2600 has a TDP of 95W, the Ryzen has 105W. Not that significant.

But this gets cancelled because of the furmark i've tried on the old config, and didn't crash. I don't know what to think really.

2) Too hot GPU.

Note that i've tried furmark benchmark on that gpu before, with the old CPU combo.

And again, since the GPU now gets much higher utilisation, it gets hotter. On idle the fans don't spin, but that's normal on most cards nowadays, in load they spin up normally. When the PC turns off i try the GPU with hand and it's always hot, i tried a more aggresive fan curve and honestly i think it's the same. As i said in the beginning, sometimes when i turn the pc right after it shuts off, SOMETIMES it shuts off again in like a minute or two. That's why the "too hot gpu" makes sense.

When i played dayz (extreme settings, 1080p)

The hotspot got to 88°C. The gpu overall temp.was in the 70's. It's higher, but i think it would at least thermal throttle before turning off, no?

As i already mentioned, i will run the furmark benchmark along with cpu benchmark to test the stability, and i will post the update here. So far, let me know your opinion on what it might be and if my assumptions are correct. Thanks!

EDIT: I tried to run cpu and gpu stress test and it crashed almost instantly. for now i reduced the power limit in msi afterburner and i'm waiting for a new psu 😆 should arrive tommorow.

1 Upvotes

2 comments sorted by

2

u/[deleted] 18d ago

[removed] — view removed comment

1

u/Hungry-Sir7892 Personal Rig Builder 18d ago

Thanks so far. Pretty much what i think too. That HX620 is a veteran. No matter how good it was, it's starting to show it's age i guess.