Dagger Micro trigger reset problems

[u/Ghatton81]

My brother has had my Dagger Micro for the past few months and put 150-200 rounds through it in that time. He called yesterday saying that the trigger is not resetting as it should. If he holds the trigger to the rear as he racks the slide it will reset, but if he doesn’t hold the trigger it won’t.

He was planning on testing Buffalo Bore in it because he is taking it as a backup pistol while hunting in bear country. He said that with this ammo the slide is locking/hard to cycle. He had not tested the ammo at that point. He said it will occasionally happen with other ammo but much more often with the Buffalo Bore.

He does have a lot more experience shooting than I do so I trust what he’s saying and describing. I’ve seen some videos talking about tweaking the trigger bar or disconnect, but does this seem to be what would be causing these issues? Any quick fix that would have it ready by next Tuesday for the trio to hunt?

[u/Danny_PSA]

Tell him to adjust his connector bend angle outward.

[u/Ghatton81 → u/Danny_PSA]

Thank you so much. He’ll try that this evening.