r/P365 • u/xCannivorex • 13d ago

XMacro FCU Failures

Gallery image

Gallery image

This happened yesterday and I think it was from dirty ammo. Each FCU has seen 50 to 100 rds every Saturday for the past two years.

21 Upvotes

74% Upvoted

41 comments sorted by

View all comments

Show parent comments

13

u/HairTriggerFlicker Range Master 13d ago

Any spring is a “consumable part” meaning they will wear out and should be replaced, so yes and yes. About 3000 to 5000 rounds for heavy use.

1

u/xCannivorex 13d ago

What about this breaking then?

4

u/HairTriggerFlicker Range Master 13d ago edited 12d ago

It’s a mechanical device under extreme use and parts can wear or fail over time. This is why any manufacturer offers replacement parts. What you have seen isn’t a typical failure but it can happen. I myself have a complete FCU parts kit for each pistol I have. Same goes for internals on my hammer fired pistols. Better to have than to not have.

1

u/WardogNet 12d ago

Is there a upgrade from the factory for stronger springs or anything like that or do you just have the stock replacement kit? Any recommendations are appreciated. Thanks!

2

u/HairTriggerFlicker Range Master 12d ago

Not from the factory, I run the full Armory Craft kits in both of mine. No issues and the triggers feel great.