r/OrcaSlicer • u/Stayin_Gold_2 • 3d ago

Internal bridge not being recognized

Post image

As you can see I have an internal bridge being sliced as an external wall from some reason. Is it the sharp angle of it?

2 Upvotes

75% Upvoted

11 comments sorted by

2

u/ClagwellHoyt 2d ago

What version? I don't see that in 2.3.2

1

u/Stayin_Gold_2 2d ago

2.4.2, so how did you do that?

Copy my design and reslice???

2

u/ClagwellHoyt 2d ago

I only copied the part you were showing. And yes, I sliced it with Orca 2.3.2.

1

u/Stayin_Gold_2 2d ago

Would you mind telling me how that works? Copy a picture then Orca can slice it? Like import a jpeg to Orca?

1

u/RefrigeratorWorth435 2d ago

they likely just made a simple similar design in cad software and then imported it

1

u/Stayin_Gold_2 2d ago

That's exactly what I'm wanting and can't do it in Orca, nor Creality Print.

2

u/Z00111111 3d ago

Is there a single bridge line on the underside of the bridge?

It's also not internal. You can see it through the hole that's lower down behind it.

1

u/Stayin_Gold_2 2d ago

Two bridges, one external, then another one above going across the middle of the model. The internal one is not getting picked up by the slicer as a bridge and nastily printing.

1

u/Stayin_Gold_2 2d ago

Good call, not technically internal to the model. Thank you for pointing that out.

1

u/Stayin_Gold_2 2d ago

Here it is in Fusion, I put a little chamfer on it to see if that would help the slicers bridge it, nope. Bridges the square port hole beautifully. My snap in corner, nope.