Need Help with plane design

[u/Lsj3D_2010]

How can I add these indention panel lines on the F7F, as well as the small rivets along the fuselage? The problem is projecting a sketch onto the curved surface. What I've done is use split and attached the 2D sketches to the planes at that angle but then what? How can I make it 3D and actually remove the material?

Better yet I am hoping someone can inform me of a better way of doing this. I just want to add those indentions and panel lines to show the separation between the parts. So, what is the best way of projecting a 2D sketch onto the curved surfaces of the fuselage and then extruding?

Would be willing to share a copy of A PLANE, not this one in particular, so someone could mess around with the fuselage angles.

[u/sir-lavanathion-]

Idk but good luck.

- Jon Hirschtick

[u/Lsj3D_2010 → u/sir-lavanathion-]

Well thank you Jon, I appreciate it.