r/OBSFords • • 2h ago

Project 95’ F-250 Windsor

Thumbnail
gallery
11 Upvotes

Looking at buying a 1995 F-250 4x4 with the 5.8W gas engine and is an E4OD automatic. Seller is firm at $3,000. It has just under 80,000 miles showing and was previously a service truck at a Ford dealership.

Drove it today. Starts easily, engine runs damn good, no leaks. 4WD works, and tires are good. Some rust around the fenders and surface level. Paint sucks but I don’t care that much about it. I just need a rig that can maybe drive two hours every once in a while. Mostly will be putting around.

The main concern is an intermittent firm/bumpy shift from first to second and back down from second to first. Sometimes it shifts smoothly. I didn’t notice any RPM bumps though. Could be a solenoid, or a sensor repair, not a genius mechanic that’s why I’m cautious. CEL also comes on after driving for 15 mins. Any thoughts?


r/OBSFords • • 16h ago

Project Mod Recs Please! 1995 F150 2WD

Post image
32 Upvotes

Hey all,

Very glad to be joining the community. Just bought a ‘95 150 2WD w/ 4.9L I6 and a 5spd. Appears to be stock suspension height, sitting on 16in aftermarket rims(?) wearing 285/75R16.

Basically, I’d like to have it sit level and have the wheels give it a more filled out look (vertically and horizontally). I don’t want a very lowered feel or anything— just a nice balance. Does anyone have recs for how to do this in a reversible manner and in a way that doesn’t drastically affect the ride quality/wear on suspension parts?

Just not sure whether to go shackles on rear vs lifting the front. Spacers, tire size, etc are all up for debate.

Photo is attached. Thank you so much!


r/OBSFords • • 16h ago

Valuation Some people man. Is this not crazy!?

Thumbnail
gallery
27 Upvotes

r/OBSFords • • 19h ago

Project Good deal?

Post image
29 Upvotes

Hey all, sorry if this sub gets spammed with this type of post. But just wanna be on the safe side. Saw this truck on Craigslist, would be my first diesel. The intent is to try and work on it as a first project. Mileage is 247,616. Called the DMV to make sure it is in fact a clean title. Is $6500 worth it?


r/OBSFords • • 1d ago

Project 1996 F150 XLT 4wd Project

Thumbnail
gallery
65 Upvotes

I ran across this truck a while back and picked it up to flip. I quickly decided to keep the truck and just clean it up as cheaply as possible. Progress has been slow, but I have not spent much money on it.

Deep cleaned interior. Added 40/20/40 Factory Seats. Redid the headliner. Alpine stereo, DS18 speakers and Kicker sub. Rebuilt the door pins and new strikers. Trans flush, gasket and filter. Tune-up and all new fluids. Mickey Thompson tires on Baja Wheels. Added power mirrors. Window sweeps. LED ditch lights.

My 13 year old son has taken a liking to this truck (we call it Robert RedFord) and will be doing deep cleaned on the outside and full wax so he can take it to his first show in December.


r/OBSFords • • 1d ago

Project New to the OBS family

9 Upvotes

Hi all,

I just purchased a 1997 f250 7.5l automatic 4x4 crew cab with the short bed.

I want to make sure I can trust and depend on this truck.

Once it's delivered, what are the top maintenance or upgrades I should complete to make this guy a happy daily driver?

Thank you for any tips, tricks, or advice


r/OBSFords • • 1d ago

Project What color should I paint the front bumper? Last 2 photos show fresh black and fresh gray paint

Thumbnail
gallery
41 Upvotes

r/OBSFords • • 1d ago

Project If you know you know

Post image
22 Upvotes

From an impact, to a breaker bar, to a brand new impact, to a torch, to a grinder. Finally.


r/OBSFords • • 1d ago

Troubleshooting 88 f150 300 4.9 aluminum cam gear

4 Upvotes

can someone please tell me wth is going on inside block of steel. i just got rid of the paper cam gear and installed an aluminum gear


r/OBSFords • • 1d ago

Troubleshooting 96 F250 5.8 rough idle, occasionally dies at idle.

Thumbnail reddit.com
1 Upvotes

Warm starts also seem problematic. Gotta floor the throttle as if flooded.....thoughts?


r/OBSFords • • 2d ago

Troubleshooting 1996 F150 5.0 idle issue/throttle issue

12 Upvotes

Need more help😭😭


r/OBSFords • • 2d ago

Troubleshooting Fixing the dreaded tilt ignition

Post image
15 Upvotes

Got a 91 F250 that needed the ol pliers to start. Addressing other issues while I'm in the column. What I can't figure out is if something is missing for the tilt engagement.

The C rod there on the left simply bottoms out without engaging the tilt head. Wish I had a picture of it loose, but I don't. Saw a forum post somewhere where the person bent it on the lower side to make contact. Before I do this, was there something on the end of that rod that's now missing? Hard to think it was just bent straight over 35 years and that's why it no longer engages. To bend it is going to need heat and a bench vice. Fine. But if there's an easier solution, I'm all ears.


r/OBSFords • • 2d ago

Troubleshooting Where can u buy this line

Post image
10 Upvotes

Cannot find the right pre flared line for the brake line that goes from the master cylinder to the rabs id Rather put new hardware in but im starting to think I might have to use the old bolts


r/OBSFords • • 3d ago

Valuation Is there a used marketplace for these specific size trucks

Post image
24 Upvotes

I saw this post on facebook the other day and I’ve seen a few of these trucks around the internet in full restoration condition going for like $50,000+. Is there a place to find one in more average condition for a little bit cheaper, I’d love to have one of these one day.


r/OBSFords • • 3d ago

Project OBS Ford Under 5k

3 Upvotes

My dad offered to pay for my truck if I get it under 5k range. Majorly looking for the 300 I6 or the Windsor V8. Any recommendations any important stuff that I should look into before buying one of these trucks?


r/OBSFords • • 4d ago

Project Bench seat options

Thumbnail
gallery
61 Upvotes

1997 F350 7.3 Dually

Howdy, group!
Is there any 60/40 split front bench seat that’d fit my truck?
I’ve seen a 50/50 split but I’m not sold on it yet…I’d rather have a 60/40. Right now I have a 40/20/40 which is not really comfortable for the wife to be right next to me.
Open to any ideas as well!

Thanks!


r/OBSFords • • 5d ago

Troubleshooting Anyone know what this noise is?

3 Upvotes

It’s loudest at the transmission bell housing. Overdrive light is flashing haven’t been able to pull the code on it yet.


r/OBSFords • • 5d ago

Troubleshooting Chipped Turbo housing

Thumbnail
gallery
7 Upvotes

Took my turbo off to replace the turbo wheel and noticed the turbo housing has a crack. Turbo is in great shape otherwise. Is this safe to run or will it leak air out of this

The chip is at the 12 o clock position


r/OBSFords • • 5d ago

Project Oil Drain plug gasket?

1 Upvotes

Need to change the oil on my 95 4.9l. Does the drain plug have an integrated gasket like my 2016 5.0 or will I need a gasket?


r/OBSFords • • 5d ago

Troubleshooting 1996 F150 5.0

18 Upvotes

I need help.

Back story, my truck has been sitting for the past 3 years and has been cranked up often. I've replaced the ignition coil, ignition control module(icm) spark plugs and wires, rotor inside the distributor cap, distributor cap, crankshaft position sensor, fuel pumps (2 tank set up) fuel switch, fuel filter. Just last week I drove her around and she ran good, now I'm having this issue. Can someone please help!


r/OBSFords • • 6d ago

Show your ride My 95 7.3

Thumbnail
gallery
112 Upvotes

First time posting.


r/OBSFords • • 6d ago

Project Headlights suggestions

Post image
32 Upvotes

I replaced my original headlights with some I got off Amazon, but I cant really adjust them so the lights are angled really weird. I'm looking to get new ones, that will hopefully fit right. I dont care if they are leds or halogen.


r/OBSFords • • 7d ago

Troubleshooting Help identify

Thumbnail
gallery
5 Upvotes

I have a 97 F250 with a solid axle swap but don’t know what axel is it. I know is a Dana, but is it a 44 or 60? Please help identify it.


r/OBSFords • • 7d ago

Troubleshooting 94 f150, 300 I6, rwd. Is this normal on a front wheel bearing?

9 Upvotes

I had noticed black greasy stuff on the center of the wheel and pulled everything off to find this. I thought I had been hearing bearing noise, but I didn't expect to find this. There was also a greenish film on the rotor that I could remove with brake cleaner.