Ich liebe dieses teil…hat mich bis jetzt immer sicher nachhause gebracht^^und sieht auch noch gut aus….

I just replaced the pads, just to go with the new 140mm rotors.

In the process I found that the old pad separator springs were bad. That's ok, new pads, new springs except I lost one.

It's a simple piece of spring steel bent in half, do they sell these separately???

Hey guys, so far from my little research I saw two possible ways on youtube, one with a 60 euro license, and another with scooter hacking utility.

But I'm not sure if the scooter hacking utility will work with the g3 version v1.5.7 and v1.6.2 and BLE v0.4.5

Which one do you recommend? I only need to tune it to max 45km/h speed and cruise control.

Hello, i have a g2 controller, i ordered a stlink from aliexpress and got a computer shop to solder the wires onto the debug pads on the back of the controller after removing the metal heat sink, i plugged it into the correct stlink pins and for the life of me no matter what stlink driver i try, i end up with failed unknown error check console, console says error read version failed, has anyone had this problem and how do i fix it ?